| Model | Nominal spools | Published temperature limits | Independent zones |
|---|---|---|---|
| Space Pi | 1 | 45–70°C | 1 |
| Space Pi V2 Plus | 2 | 75°C ceiling; minimum unverified | 1 |
| SpacePi X4 | 4 | 45–85°C | 2 |
Choose the single-spool Space Pi for a single-reel queue
Start with how many reels you genuinely prepare at once. If most projects consume one reel and you can dry the next one later, the original Space Pi keeps the decision focused on the material instructions, the control interface and physical clearance. Its 70°C ceiling does not say how quickly a loaded reel reaches the required condition. Compare measured tests only when the material, load and cycle are comparable.
Choose V2 Plus for two reels that share a recipe
The V2 Plus adds a second spool position. That is useful for preparing a two-colour job or two reels of the same material together, provided both exact products permit the same process. Two reels are not two independently selected temperatures. If one material needs a lower setting, plan separate cycles or a genuinely divided dryer rather than averaging their instructions. Its published ceiling is 75°C. Older Plus documentation lists 70°C, so check the revision on the actual unit.
Choose X4 when two schedules matter
X4 has two independently controlled chambers and a published 85°C ceiling. Those are separate benefits: a four-reel batch with identical requirements might need capacity without needing two zones. Conversely, two incompatible recipes may justify divided chambers even when every spool position is not occupied. Check how your reel widths fit each chamber before treating nominal capacity as usable capacity.
Compare the complete regional purchase
The V2 Plus was sold out on the official US page when checked on 13 September 2026. Verify your regional listing before treating it as an available purchase. For X4, Creality says PTFE tube is not included in the standard product. Add any needed tubes and accessories to your comparison, and confirm voltage, plug and returns. X4L is a separate model outside this three-way comparison.
Models to compare
Single spool
Creality Space Pi
A one-spool dryer with a documented 45–70°C setting range.
- Spools*
- 1
- Max temp
- 70°C
- Zones
- 1
The original Space Pi is a different size from the two-spool Plus and four-spool X4.
Model details →
Two-spool chamber
Creality Space Pi V2 Plus
Two-spool capacity for a batch that shares one drying schedule.
- Spools*
- 2
- Max temp
- 75°C
- Zones
- 1
V2 Plus has a 75°C published ceiling; the US listing showed sold out on 13 September 2026.
Model details →
Two controlled zones
Creality SpacePi X4
Four-spool capacity split across two independently controlled chambers.
- Spools*
- 4
- Max temp
- 85°C
- Zones
- 2
The X4 has a published 45–85°C range. Do not substitute specifications for the newer X4L.
Model details →Sources for this comparison
- Creality Space Pi official product information
- Creality Space Pi Plus official product information
- Creality SpacePi X4 official product information
- Creality X4 technical parameters
- Creality Cloud Plus documentation
- Creality VIP: V2 Plus 75°C ceiling
Specifications checked 13 September 2026. Editorial buying analysis; no hands-on test is claimed.